How to repair and maintain the ultrasonic cleaning machine

一、禁止将导电液体(如水)放入超声波控制柜顶部的进风口。否则会严重损坏清洗机的管路系统。

1、 It is forbidden to put conductive liquid (such as water) into the air inlet at the top of the ultrasonic control cabinet. Otherwise, the pipeline system of the cleaning machine will be seriously damaged.

二、注意保持超声波清洗机清洁，不使用时请关掉电源。

2、 Pay attention to keep the ultrasonic cleaner clean. Please turn off the power when not in use.

三、请勿对超声波清洗机碰撞或剧烈震动。

3、 Do not bump or vibrate the ultrasonic cleaner.

四、让全自动超声波清洗机远离热源。

4、 Keep the automatic ultrasonic cleaner away from heat source.

五、机器应避免在潮湿的环境中存放，长期存放容易导致设备氧化生锈，线路潮湿。

5、 The machine should not be stored in a humid environment. Long term storage will easily lead to oxidation and rust of the equipment and damp circuit.

                   

六、超声波清洗机的连续工作时间不应超过4小时。如果连续工作时间过长，应将超声波清洗机调节旋钮旋转到“0”位置，冷却风扇应继续工作，在超声波清洗不启动的情况下，超声波控制柜内的连续散热应至少2分钟。

6、 The continuous working time of ultrasonic cleaning machine should not exceed 4 hours. If the continuous working time is too long, the adjusting knob of the ultrasonic cleaning machine should be turned to "0" position, the cooling fan should continue to work, and the continuous heat dissipation in the ultrasonic control cabinet should be at least 2 minutes when the ultrasonic cleaning is not started.

七、经长时间运行的清洗机，在?；坝β市サ髦亮阄?，使用其风机再工作3-6分钟后关机，以保证电源内部热量散出。

7、 After a long time of operation, the power knob should be adjusted to zero before shutdown, and the fan should be used to work for another 3-6 minutes before shutdown, so as to ensure that the heat inside the power supply is dissipated.

八、清洗后，全自动超声波清洗机的清洗液应及时沉淀、过滤或更换，以保证清洗效果。

8、 After cleaning, the cleaning solution of the automatic ultrasonic cleaning machine should be precipitated, filtered or replaced in time to ensure the cleaning effect.